英语
中文简体Ride-on scrubber or hand-push scrubber, the more important functional accessory is the scrubber squeegee, the correct adjustment of the squeegee can make the scrubber absorb water more cleanly, usually our scrubber squeegee is before the factory. It has been debugged. The suction grill corresponds to the machine. Please do not change it at will. After the replacement, it may operate the water absorption effect. It also needs to be adjusted when replacing it at ordinary times. Some friends don’t understand it very well. How to adjust the angle of the squeegee:
Park the washing machine on a level ground, and make the squeegee of the driving washing machine 90° vertical to the ground. When the rubber strip is worn, the system will automatically compensate. Do not easily change the position of the adjusting screw shown in the figure below. The pressure of the suction rubber strip is coordinated by the height of the universal wheel. After adjustment, it should be locked by the wing nut to keep the suction rubber strip in the proper position with the ground.
If the suction scoop and the ground are not at 90°, it may cause poor wiping at the center of the suction scoop, and cause the rubber strips at both ends to be too close to the ground, causing excessive wear of the rubber strips, and even causing the two ends of the front rubber strip to dislocate.
If there is poor wiper in the middle or bad wiper at both ends during the operation of the driving scrubber, we can adjust the knob in the figure below to eliminate it. Note (non-professionals should not adjust easily), the adjustment steps of the scrubber squeegee (below): Loosen the adjusting screw of the lock nut, observe the change of the suction squeegee, until the suction squeegee is evenly attached to the ground, and then tighten the nut
